Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY



B355114E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    8 (AU3) - 7 (EAU)
    9 (AU2) - 7 (EAU)
    10 (AU1) - 7 (EAU)
    No switch is pushed
    100 kΩ or higher
    8 (AU3) - 7 (EAU)
    RIGHT switch pushed
    1000 Ω
    LEFT switch is pushed
    3110 Ω
    8 (AU3) - 7 (EAU)
    ENTER switch pushed
    Below 2.5 Ω
    BACK switch pushed
    329 Ω
    9 (AU2) - 7 (EAU)
    MODE HOLD switch is pushed
    Below 2.5 Ω
    9 (AU2) - 7 (EAU)
    OFF HOOK switch is pushed
    1000 Ω
    ON HOOK switch is pushed
    329 Ω
    VOICE switch is pushed
    3110 Ω
    10 (AU1) - 7 (EAU)
    VOLUME+ switch is pushed
    1000 Ω
    VOLUME- switch is pushed
    3110 Ω
    10 (AU1) - 7 (EAU)
    UP switch pushed
    Below 2.5 Ω
    DOWN switch pushed
    329 Ω
    2 (+DP) - 3 (-DP)
    DISP switch is pushed
    Below 2.5 Ω

    If the result is not as specified, replace the steering pad switch assembly.