STEERING PAD SWITCH > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE LOWER NO. 2 STEERING WHEEL COVER |
![]() |
w/ Cruise Control:
| *1 | Protective Tape |
Using a screwdriver, detach the claw and guide and remove the lower No. 2 steering wheel cover.
![]() |
w/o Cruise Control:
| *1 | Protective Tape |
Using a screwdriver, detach the claw and guide and remove the lower No. 2 steering wheel cover.
| 4. REMOVE LOWER NO. 3 STEERING WHEEL COVER |
![]() |
Using a screwdriver, detach the claw and guide and remove the lower No. 3 steering wheel cover.
| *1 | Protective Tape |
| 5. REMOVE STEERING PAD |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
Pull the steering pad toward you.
![]() |
Disconnect the horn connector from the steering pad.
Using a screwdriver, release the 2 airbag connector locks.
| *1 | Protective Tape |
Disconnect the 2 airbag connectors and remove the steering pad as shown in the illustration.
| 6. REMOVE STEERING PAD SWITCH ASSEMBLY |
![]() |
Disconnect each connector.
Remove the 4 screws.
![]() |
Detach the 6 guides and 2 claws and remove the steering pad switch assembly.