Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for CrewMax)

FRONT DOOR SPEAKER (for CrewMax) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH


    B168274E02
  1. Detach the 3 clips and remove the front lower door frame bracket garnish.



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH


    B165648E02
  1. Using a screwdriver, detach the 4 claws and remove the inside handle bezel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT UPPER ARMREST BASE PANEL LH


    B360301
  1. Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel LH.



    B360303
  1. Disconnect the master switch connector.



4. REMOVE FRONT DOOR ARMREST COVER LH


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B354849E01
  1. Remove the 2 screws.

  1. Remove the clip.

  1. Detach the 9 clips and remove the trim board cover. Then disconnect the connector.



    B165654E01
  1. Disconnect the 2 cables from the inside handle.

  1. Remove the inside handle.



6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


  1. Remove the 4 screws.


    B356596E03


    Text in Illustration 
    *A
    for Standard
    *B
    for 12 Speakers

    NOTICE:
    Do not touch the cone part of the speaker.

  1. Disconnect the connector and remove the front No. 1 speaker assembly.



7. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 12 Speakers)


    B171783
  1. Remove the 3 screws and front No. 3 speaker assembly with the bracket.



    B165754E01
  1. Detach the 3 claws and remove the front No. 3 speaker assembly from the bracket.

    NOTICE:
    Do not touch the cone part of the speaker.