Home › BODY ELECTRICAL › AUDIO / VISUAL › INSTRUMENT PANEL SPEAKER (for Regular Cab)

INSTRUMENT PANEL SPEAKER (for Regular Cab) > REMOVAL

for Preparation Click here



1. REMOVE FRONT PILLAR GARNISH LH


    B355361E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the claw and open the cover.

    HINT:
    Tape the screwdriver tip before use.



    B355363
  1. Remove the bolt.

  1. Detach the clip and remove the front pillar garnish LH.



  1. Protect the curtain shield airbag assembly.



      B165709E07
    1. Completely cover the curtain shield airbag assembly with a cloth or nylon sheet and secure the ends of the cover with adhesive tape as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag assembly with a protective cover as soon as the front pillar garnish LH is removed.

      Text in Illustration 
      *1
      Adhesive Tape
      *2
      Protective Cover
      *3
      Curtain Shield Airbag Assembly



2. REMOVE FRONT PILLAR GARNISH RH


    B355364E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 2 claws and open the 2 assist grip covers.

    HINT:
    Tape the screwdriver tip before use.



    B355366
  1. Remove the 2 bolts and front assist grip sub-assembly from the front pillar garnish RH.



    B355367
  1. Detach the clip and remove the front pillar garnish RH.

  1. Protect the curtain shield airbag assembly.

    1. Completely cover the curtain shield airbag assembly with a cloth or nylon sheet and secure the ends of the cover with adhesive tape.

      NOTICE:
      Cover the curtain shield airbag assembly with a protective cover as soon as the front pillar garnish RH is removed.



3. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


B355102E01
Text in Illustration 
*1
Protective Tape
  1. Apply protective tape as shown in the illustration.

  1. Using moulding remover B, detach the 3 clips, 3 claws and 2 guides and remove the No. 1 instrument panel speaker panel sub-assembly.



4. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


B355103E01
Text in Illustration 
*1
Protective Tape
  1. Apply protective tape as shown in the illustration.

  1. Using moulding remover B, detach the 3 clips, 3 claws and 2 guides and remove the No. 2 instrument panel speaker panel sub-assembly.



5. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY LH


B355113
  1. Remove the 2 bolts.

  1. Disconnect the connector and remove the front No. 2 speaker assembly LH.

    NOTICE:
    Do not touch the cone part of the speaker.



6. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY RH


B355112
  1. Remove the 2 bolts.

  1. Disconnect the connector and remove the front No. 2 speaker assembly RH.

    NOTICE:
    Do not touch the cone part of the speaker.