Home › BODY ELECTRICAL › DOOR LOCK › DOOR CONTROL RECEIVER (for Double Cab)

DOOR CONTROL RECEIVER (for Double Cab) > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH


    B165598
  1. Pull the 2 reclining adjusting handles and fold up the seat cushion.



    B356738
  1. Turn the knob and open the luggage compartment side cover sub-assembly LH.

  1. Detach the hooks and remove the luggage compartment side cover sub-assembly LH.



2. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH


    B356739
  1. Turn the knob and open the luggage compartment side cover sub-assembly RH.

  1. Detach the hooks and remove the luggage compartment side cover sub-assembly RH.



3. REMOVE SEAT FLOOR BOX


B165790
  1. Remove the 4 knobs.

  1. Detach the claw and remove the seat floor box.



4. REMOVE REAR SEAT ASSEMBLY


    B165599
  1. Pull out the rear seat inner belt assemblies.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
  1. Remove the rear door opening trim weatherstrip .

    HINT:
    The procedures listed below are for the LH side.



6. REMOVE REAR DOOR SCUFF PLATE RH
  1. Remove the rear door scuff plate .

    HINT:
    The procedures listed below are for the LH side.



7. REMOVE LOWER QUARTER TRIM PANEL ASSEMBLY RH
  1. Remove the lower quarter trim panel assembly .

    HINT:
    The procedures listed below are for the LH side.



8. REMOVE DOOR CONTROL RECEIVER


B165415E01
  1. Disconnect the connector.

  1. Remove the bolt and door control receiver.