STEREO JACK ADAPTER ASSEMBLY (for Floor Shift Type) > REMOVAL |
| 1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.
| 2. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY |
Move the shift lever to N.
![]() |
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.
| 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 clips and remove the upper console panel sub-assembly.
| 4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY |
Put protective tape around the air conditioning control assembly.

| *A | for Automatic Air Conditioning System | *B | for Manual Air Conditioning System |
| *1 | Protective Tape | *2 | Air Conditioning Control Assembly |
| *3 | Center Lower Instrument Panel Finish Panel | - | - |
Using moulding remover B, detach the 8 clips, 2 claws and guide.
Disconnect each connector and remove the air conditioning control assembly together with the center lower instrument panel finish panel.
![]() |
Detach the 3 clips and remove the air conditioning control assembly from the center lower instrument panel finish panel.
| *1 | Air Conditioning Control Assembly |
| *2 | Center Lower Instrument Panel Finish Panel |
| 5. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY |
![]() |
Detach the 2 claws and remove the No. 1 stereo jack adapter assembly.