Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C159312
  1. Remove the bolt and disconnect the brake tube bracket from the steering knuckle.



    C159313
  1. Remove the 2 bolts and disconnect the disc brake caliper from the steering knuckle.

    NOTICE:
    1. Do not disconnect the flexible hose from the disc brake caliper.
    2. Do not twist or bend the flexible hose.



3. REMOVE FRONT DISC


    C155464E01
  1. Put matchmarks on the front disc and axle hub if planning to reuse the disc.

  1. Remove the front disc.



4. REMOVE FRONT AXLE LH HUB BOLT


    C159308E02
  1. Using SST and a screwdriver or equivalent to hold the axle hub, remove the front axle hub bolt.

    SST
    09650-17011  

    NOTICE:
    Do not damage the threads of the hub bolts.



5. INSTALL FRONT AXLE LH HUB BOLT


    C159309E02
  1. Temporarily install a washer and hub nut to a new hub bolt as shown in the illustration.

    NOTICE:
    Install hub nuts to prevent damage to the hub bolts.

  1. Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.

  1. Remove the washer and hub nut.

    NOTICE:
    Do not damage the threads of the hub bolts.



6. INSTALL FRONT DISC


    C155464E01
  1. Align the matchmarks, and then install the front disc.

    HINT:
    When replacing the front disc with a new one, select the installation position where the front disc has the smallest runout.



7. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C159313
  1. Connect the front disc brake caliper and install 2 new bolts.

    Torque:
    99 N*m{ 1010 kgf*cm , 73 ft.*lbf }

    NOTICE:
    1. Do not twist the flexible hose.
    2. Make sure that the bolts are free from damage and foreign matter.
    3. Do not overtighten the bolts.



    C159312
  1. Connect the brake tube bracket to the steering knuckle with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }