Home › BRAKE › BRAKE CONTROL › STOP LIGHT CONTROL RELAY

STOP LIGHT CONTROL RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK STOP LIGHT CONTROL RELAY
  1. Remove the stop light control relays (BRK NO. 1 and BRK NO. 2) from the engine room relay block.



    C211690E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for BRK NO. 1 
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    When battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    3 - 4
    When battery voltage is applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω
    for BRK NO. 2 
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.

  1. Install the stop light control relays (BRK NO. 1 and BRK NO. 2).