Home › DRIVE LINE › WF1AM TRANSFER › TRANSFER OIL

TRANSFER OIL > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK TRANSFER OIL


    C291183
  1. Remove the transfer case plug (filler).



    C083746E10
  1. Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the transfer case plug (filler) hole.
    If the result is not as specified, add Toyota Genuine Transfer gear oil LF 75W or equivalent.
    Text in Illustration 
    *a
    0 to 5.0 mm (0 to 0.196 in.)

    Viscosity:
    SAE 75W

    Standard Capacity:
    1.4 to 1.5 liters (1.48 to 1.58 US qts., 1.24 to 1.32 Imp. qts.)

    NOTICE:
    1. After changing the oil, drive the vehicle and check the oil level again.
    2. Too much or too little oil will lead to transfer problems.

  1. When the oil level is too low, check for oil leaks.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new transfer case plug (filler).

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }