Home › BODY ELECTRICAL › LIGHTING › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER


E277435E01
  1. Disconnect the turn signal flasher connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    4 (E) - Body ground
    Always
    Below 1 Ω

  1. Connect the turn signal flasher connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    8 (LR) - 4 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    Alternating between 11 to 14 V and below 1 V (60 to 120 times per minute)
    2 (LL) - 4 (E)
    Hazard warning switch off
    Below 1 V
    Hazard warning switch on
    Alternating between 11 to 14 V and below 1 V (60 to 120 times per minute)
    1 (B) - 4 (E)
    Always
    11 to 14 V
    6 (EL) - 4 (E)
    Ignition switch ON Headlight dimmer switch (turn left) off
    9 V or higher
    Ignition switch ON Headlight dimmer switch (turn left) on
    Below 1 V
    7 (ER) - 4 (E)
    Ignition switch ON Headlight dimmer switch (turn right) off
    9 V or higher
    Ignition switch ON Headlight dimmer switch (turn right) on
    Below 1 V
    12 (HAZ) - 4 (E)
    Hazard warning switch off
    9 V or higher
    Hazard warning switch on
    Below 1 V

    If the result is not as specified, there may be a malfunction in the turn signal flasher.
    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Turn Signal Flasher)