TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM > TERMINALS OF ECU |
| CHECK 4 WHEEL DRIVE CONTROL ECU |

| *a | Component with harness connected (4 Wheel Drive Control ECU) | - | - |
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| A25-1 (DM1) - A25-5 (GND) | W - W-B | A. D. D. shift motor output | Ignition switch ON Transfer position switch 4H → 2WD (during A.D.D. actuator Lock to Free operation) | 10 to 14 V |
| A25-2 (DM2) - A25-5 (GND) | Y - W-B | A. D. D. shift motor output | Ignition switch ON Transfer position switch 2WD → 4H (during A.D.D. actuator Free to Lock operation) | 10 to 14 V |
| A25-5 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| A25-6 (B) - A25-5 (GND) | G - W-B | ECU power supply | Always | 11 to 14 V |
| A25-7 (DL1) - A25-5 (GND) | LG - W-B | A.D.D. actuator limit switch input | Ignition switch ON Transfer position 2WD (A.D.D. actuator Free) | 10.5 to 14 V |
| Ignition switch ON Transfer position 4WD (A.D.D. actuator Lock) | Below 1.5 V | |||
| A25-11 (LO) - A25-5 (GND) | P - W-B | Transfer position switch input | Ignition switch ON Transfer position switch 2WD | 10.5 to 14 V |
| Ignition switch ON Transfer position switch 4H | Below 1.5 V | |||
| Ignition switch ON Transfer position switch 4L | Below 1 V | |||
| A25-12 (2-4) - A25-5 (GND) | B - W-B | Transfer position switch input | Ignition switch ON Transfer position switch 2WD | Below 1 V |
| Ignition switch ON Transfer position switch 4H | Below 1.5 V | |||
| Ignition switch ON Transfer position switch 4L | 10.5 to 14 V | |||
| A25-16 (IG) - A25-5 (GND) | V - W-B | IG power | Ignition switch ON | 11 to 14 V |
| A25-18 (ADD) - A25-5 (GND) | GR - W-B | A.D.D. detection switch input | Ignition switch ON Transfer position 2WD | 10 to 14 V |
| Ignition switch ON Transfer position 4WD | Below 1.5 V | |||
| A25-20 (DL2) - A25-5 (GND) | R - W-B | A.D.D. actuator limit switch input | Ignition switch ON Transfer position 2WD (A.D.D. actuator Free) | Below 1.5 V |
| Ignition switch ON Transfer position 4WD (A.D.D. actuator Lock) | 10.5 to 14 V | |||
| A25-23 (CANH) - A25-22 (CANL) | BE - W | CAN communication line | Ignition switch off | 54 to 69 Ω |
| A26-1 (TM1) - A25-5 (GND) | R - W-B | Transfer shift motor output | Ignition switch ON Shift lever in N Transfer position switch turned from 2WD to 4H (switching from 2WD to 4H) Transfer position switch turned from 4H to 4L (switching from 4H to 4L) | 10 to 14 V |
| A26-2 (TM2) - A25-5 (GND) | W - W-B | Transfer shift motor output | Ignition switch ON Shift lever in N Transfer position switch turned from 4L to 4H (switching from 4L to 4H) Transfer position switch turned from 4H to 2WD (switching from 4H to 2WD) | 10 to 14 V |
| A26-6 (SCC) - A25-5 (GND) | L - W-B | Solenoid coil output | Ignition switch ON Transfer position switch turned from 2WD to 4H (switching from 2WD to 4H)) | 10 to 14 V |
| A26-12 (H4) - A25-5 (GND) | BE - W-B | Transfer indicator switch input | Ignition switch ON Transfer position not in 4L | 4 to 6 V |
| Ignition switch ON Transfer position 4L | Below 1.5 V | |||
| A26-13 (L4) - A25-5 (GND) | B - W-B | Transfer indicator switch input | Ignition switch ON Transfer position not in 4L | 11 to 14 V |
| Ignition switch ON Transfer position 4L | Below 1.5 V | |||
| A26-18 (TL1) - A25-5 (GND) | V - W-B | Transfer shift actuator limit switch input | Ignition switch ON Not switching driving mode | 4 to 6 V |
| Ignition switch ON Switching driving mode | 4 to 6 V ←→ Below 1.5 V | |||
| A26-20 (TL2) - A25-5 (GND) | BR - W-B | Transfer shift actuator limit switch input | Ignition switch ON Not switching driving mode | 4 to 6 V |
| Ignition switch ON Switching driving mode | 4 to 6 V ←→ Below 1.5 V | |||
| A26-22 (GTL) - A25-5 (GND) | P - W-B | Transfer shift actuator limit switch GND input | Ignition switch ON Not switching driving mode | 4 to 6 V |
| Ignition switch ON Switching driving mode | Below 1.5 V | |||
| A26-24 (TL4) - A25-5 (GND) | SB - W-B | Transfer shift actuator limit switch input | Ignition switch ON Not switching driving mode | 4 to 6 V |
| Ignition switch ON Switching driving mode | 4 to 6 V ←→ Below 1.5 V | |||
| A26-26 (TL3) - A25-5 (GND) | W - W-B | Transfer shift actuator limit switch input | Ignition switch ON Not switching driving mode | 4 to 6 V |
| Ignition switch ON Switching driving mode | 4 to 6 V ←→ Below 1.5 V |