Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit


DESCRIPTION

This circuit provides power to operate the main body ECU.

WIRING DIAGRAM


B165957E02


INSPECTION PROCEDURE

1.INSPECT FUSE (DR/LCK, ECU-B1)
  1. Remove the DR/LCK fuse from the main body ECU.

  1. Remove the ECU-B1 fuse from the engine room junction block unit B.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    DR/LCK fuse
    Always
    Below 1 Ω
    ECU-B1 fuse



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY AND BODY GROUND)


    B360091E01
  1. Disconnect the DA and DB main body ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    DB-13 (BECU) - Body ground
    Always
    11 to 14 V
    DA-1 (ALTB) - Body ground

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    DB-21 (GND1, GND2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)