THEFT DETERRENT SYSTEM > Ignition Switch Circuit |

| 1.READ VALUE USING TECHSTREAM (IGNITION SWITCH) |
Using the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG SW | Ignition switch / ON or OFF | ON: Ignition switch ON OFF: Ignition switch off | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FUSE (AM1, ECU-IG No. 2) |
Remove the AM1 and ECU-IG No. 2 fuses from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| AM1 fuse | Always | Below 1 Ω |
| ECU-IG No. 2 fuse |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BATTERY) |
![]() |
Disconnect the DA main body ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DA-1 (IG) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT IGNITION SWITCH |
![]() |
Remove the ignition switch.
For 1GR-FE, refer to the following procedures (Click here).
For 1UR-FE, refer to the following procedures (Click here).
For 3UR-FE, refer to the following procedures (Click here).
For 3UR-FBE, refer to the following procedures (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 (IG1) - 4 (AM1) | Ignition switch ON | Below 1 Ω |
| Result | Proceed to |
| OK | A |
| NG (for 1GR-FE) | B |
| NG (for 1UR-FE) | C |
| NG (for 3UR-FE) | D |
| NG (for 3UR-FBE) | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - IGNITION SWITCH AND BODY GROUND) |

Disconnect the DB and DD main body ECU connector.
Disconnect the J9 ignition switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| DD-47 - J9-4 (AM1) | Always | Below 1 Ω |
| DD-43 - J9-1 (IG1) | ||
| DB-21 - Body ground | ||
| DD-47 - Body ground | Always | 10 kΩ or higher |
| DD-43 - Body ground |
|
| ||||
| OK | ||
| ||