Home › TRANSMISSION · A760E AUTOMATIC TRANSMISSION › SHIFT LEVER ASSEMBLY (for Column Shift Type)

SHIFT LEVER ASSEMBLY (for Column Shift Type) > INSPECTION

for Preparation Click here



1. INSPECT COLUMN SHIFT SHIFT LEVER SUB-ASSEMBLY


C159524E03
  1. Disconnect the transmission control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    6 (IG) - 13 (S)
    Shift lever in S, "+" or "-"
    Below 1 Ω
    5 (SFTU) - 11 (E)
    Shift lever held in "+" (Up-shift)
    4 (SFTD) - 11 (E)
    Shift lever held in "-" (Down-shift)
    6 (IG) - 13 (S)
    Shift lever not in S, "+" or "-"
    10 kΩ or higher
    5 (SFTU) - 11 (E)
    Shift lever in S
    4 (SFTD) - 11 (E)

    If the result is not as specified, replace the column shift shift lever sub-assembly.