SHIFT LEVER ASSEMBLY (for Floor Shift Type) > INSPECTION |
| 1. INSPECT TRANSMISSION CONTROL SWITCH |
Disconnect the transmission control switch connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (IG) - 7 (S) | Shift lever position S, "+" or "-" | Below 1 Ω |
| 2 (SFTU) - 5 (E) | Shift lever position continuously shifted to "+" (Up-shift) | |
| 1 (SFTD) - 5 (E) | Shift lever position continuously shifted to "-" (Down-shift) | |
| 3 (IG) - 7 (S) | Shift lever position not in S | 10 kΩ or higher |
| 2 (SFTU) - 5 (E) | Shift lever position S | |
| 1 (SFTD) - 5 (E) |
| *a | Component without harness connected (Transmission Control Switch) |