Home › BODY › WINDSHIELD / WINDOWGLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH


    E278381
  1. Using a moulding remover A, detach the 2 clips and 5 claws, and remove the rear upper door armrest base panel LH.



    E278383
  1. Disconnect the connector.



2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    E278384
  1. Detach the 2 claws and remove the rear power window regulator switch assembly.