Home › DRIVE LINE › WF1AM TRANSFER › 4WD CONTROL ECU

4WD CONTROL ECU > INSTALLATION

for Preparation Click here



1. INSTALL 4 WHEEL DRIVE CONTROL ECU
  1. Connect the 2 connectors.



    C291195E01
  1. Install the 4 wheel drive control ECU with the 2 bolts, and then tighten them in the order shown in the illustration.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. Be careful not to drop the 4 wheel drive control ECU.
    2. Do not subject the 4 wheel drive control ECU to strong shocks.



2. INSTALL CLEARANCE WARNING ECU WITH BRACKET



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
  1. for Column Shift Type:
  2. for Floor Shift Type:


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).