Home › DRIVE LINE › WF1AM TRANSFER › 4WD CONTROL ECU

4WD CONTROL ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
  1. for Column Shift Type:
  2. for Floor Shift Type:


4. REMOVE CLEARANCE WARNING ECU WITH BRACKET



5. REMOVE 4 WHEEL DRIVE CONTROL ECU


    C291195
  1. Disconnect the 2 connectors.

  1. Remove the 2 bolts and 4 wheel drive control ECU.

    NOTICE:
    1. Be careful not to drop the 4 wheel drive control ECU.
    2. Do not subject the 4 wheel drive control ECU to strong shocks.