Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › AIR INJECTION DRIVER

AIR INJECTION DRIVER > INSTALLATION

for Preparation Click here



1. INSTALL AIR INJECTION CONTROL DRIVER
  1. Install the air injection control driver with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



2. INSTALL AIR INJECTION CONTROL DRIVER ASSEMBLY
  1. Install the air injection control driver assembly with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Attach the 2 wire harness clamps.

  1. Connect the wire harness to the air injection control bracket with the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the 2 air injection control driver connectors.