Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › PRESSURE SWITCH

PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY


    B353342E01
  1. Put protective tape around the radiator grille sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 4 screws and 2 clips.



    B353345
  1. Detach the 4 claws and 3 clips and remove the radiator grille sub-assembly.



2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



3. REMOVE PRESSURE SWITCH


    E281042E01
  1. Disconnect the connector.

  1. Using a 27 mm deep socket wrench, remove the pressure switch.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.