Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT SWITCH

ROOM LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT INTERIOR ROOM LIGHT SWITCH ASSEMBLY


E281396E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (FCTY) - 11 (FLMP)
      Interior room light switch DOOR
      Below 1 Ω
      11 (FLMP) - 8 (E)
      Interior room light switch ON
      Below 1 Ω

      If the result is not as specified, replace the interior room light switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Interior Room Light Switch Assembly)



    E281396E02
  1. Check the illumination.

    1. Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (ILL+)
      Battery negative (-) → Terminal 4 (ILL-)
      Illuminates

      If the result is not as specified, replace the interior room light switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Interior Room Light Switch Assembly)