Home › STEERING › STEERING COLUMN › MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column)

MULTIPLEX TILT AND TELESCOPIC ECU (for Power Tilt and Power Telescopic Steering Column) > INSTALLATION

for Preparation Click here



1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


    C159704
  1. Install the ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the 2 ECU connectors.



2. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY


    C154523
  1. Remove the bolt and air duct.



3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225998
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 2 claws to install the DLC3.

  1. Install the 4 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Operate the tilt lever to fully extend and raise the steering column.



    B355337E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 bolts <A>.

  1. Detach the 9 clips, 2 claws and remove the lower instrument panel finish panel sub-assembly LH.

  1. Disconnect each connector.



    B355336
  1. Detach the 3 hooks and disconnect the hood lock control lever from the lower instrument panel finish panel sub-assembly LH.



  1. Pull and slide the hood lock control cable, rotate the hood lock control cable, and then disconnect the hood lock control cable from the hood lock control lever.


    B355339



5. INSTALL LOWER STEERING COLUMN COVER


    C160536
  1. Attach the 2 claws to install the steering column lower cover.



6. INSTALL UPPER STEERING COLUMN COVER


    C162097
  1. Attach the claw to install the upper steering column cover.

  1. Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.



    C160535
  1. Install the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    HINT:
    Turn the steering wheel to the right and left as necessary to install the 2 screws.



7. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable. some systems need to be initialized after the cable is reconnected (Click here)



8. CHECK SRS WARNING LIGHT
(Click here)