Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door)

POWER WINDOW REGULATOR MOTOR (for Rear Door) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
  1. Apply MP grease to the sliding and rotating areas of the regulator motor.



    B166252
  1. Using a T25 ''TORX'' driver, install the motor with the 3 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    HINT:
    For a new rear window regulator, the installation position of the regulator will be set when the self-tapping screws are installed.



2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
  1. for Double Cab:
    Install the rear door window regulator sub-assembly LH .

  1. for CrewMax:
    Install the rear door window regulator sub-assembly LH .



3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
  1. for Double Cab:
    Install the rear door glass sub-assembly LH .

  1. for CrewMax:
    Install the rear door glass sub-assembly LH .



4. INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
  1. for Double Cab:
    Install the rear door rear lower window frame sub-assembly LH .

  1. for CrewMax:
    Install the rear door rear lower window frame sub-assembly LH .



5. INSTALL REAR DOOR GLASS RUN LH
  1. for Double Cab:
    Install the rear door glass run LH .

  1. for CrewMax:
    Install the rear door glass run LH .



6. INSTALL REAR DOOR SERVICE HOLE COVER LH
  1. for Double Cab:
    Install the rear door service hole cover LH .

  1. for CrewMax:
    Install the rear door service hole cover LH .



7. INSTALL REAR NO. 2 DOOR TRIM BRACKET
  1. for Double Cab:
    Install the rear No. 2 door trim bracket .

  1. for CrewMax:
    Install the rear No. 2 door trim bracket .



8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. for Double Cab:
    Install the rear door trim board sub-assembly LH .

  1. for CrewMax:
    Install the rear door trim board sub-assembly LH .



9. INSTALL REAR DOOR FRAME GARNISH LH
  1. for Double Cab:
    Install the rear door frame garnish LH .

  1. for CrewMax:
    Install the rear door frame garnish LH .



10. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH
  1. for Double Cab:
    Install the rear upper door armrest base panel LH .

  1. for CrewMax:
    Install the rear upper door armrest base panel LH .



11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
  1. for Double Cab:
    Install the rear door inside handle bezel plug LH .

  1. for CrewMax:
    Install the rear door inside handle bezel plug LH .



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).