Home › DRIVE LINE › WF1AM TRANSFER › TRANSFER OIL

TRANSFER OIL > REPLACEMENT

for Preparation Click here



1. DRAIN TRANSFER OIL
  1. Remove the lower transfer case protector .



    C291184E01
  1. Remove the transfer case plug (filler) and transfer case plug (drain), and drain the transfer oil.
    Text in Illustration 
    *1
    Transfer Case Plug (Filler)
    *2
    Transfer Case Plug (Drain)



2. ADD TRANSFER OIL
  1. Install a new transfer case plug (drain).

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

  1. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the transfer case plug (filler) hole.

    NOTICE:
    1. Add oil slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new transfer case plug (filler).

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

  1. Install the lower transfer case protector .