Home › ENGINE ยท 3UR-FBE › EMISSION CONTROL › PCV VALVE

PCV VALVE > INSTALLATION

for Preparation Click here



1. INSTALL PCV VALVE SUB-ASSEMBLY


    A307670E01
  1. Apply a light coat of engine oil to the O-ring, and install it to the PCV valve sub-assembly.
    Text in Illustration 
    *1
    O-Ring

    HINT:
    1. When reusing the PCV valve sub-assembly, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the PCV valve sub-assembly.

  1. Install the PCV valve sub-assembly to the separator case.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



2. INSTALL PCV VALVE HOSE
  1. Install the PCV valve hose, and slide the clamp to secure the hose to the PCV valve sub-assembly.



3. INSTALL NO. 2 ENGINE COVER


A307709

NOTICE:
Make sure that the No. 2 engine cover is level with the top surface of the intake port if the cylinder head.

HINT:
  1. Align the No. 2 engine cover cutout with the air tube.
  2. Align the No. 2 engine cover with the front water by-pass joint and cylinder head wall.



4. INSTALL INTAKE MANIFOLD
(Click here)