Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH

CLEARANCE SONAR MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY


    B354824E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (IG) - 8 (SK)
    Sonar switch off
    10 kΩ or higher
    Sonar switch on
    Below 1 Ω

    If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

  1. Check that the switch illuminates.

    OK:
    Tester Connection
    Specified Condition
    Battery positive (+) → Terminal 1 (ILL+)
    Battery negative (-) → Terminal 6 (ILL-)
    Illuminates

    If the result is not as specified, replace the back sonar or clearance sonar switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Sonar or Clearance Sonar Switch Assembly)