Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column) > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE UPPER STEERING COLUMN COVER


    C290075
  1. Remove the 2 screws.

    HINT:
    Turn the steering wheel to the right and left as necessary to remove the 2 screws.

  1. Detach the 4 clips.



    C290076
  1. Detach the claw to remove the upper steering column cover.



2. REMOVE LOWER STEERING COLUMN COVER


    C290077
  1. Detach the 2 claws to remove the lower steering column cover.



3. INSPECT TILT MOTOR


    C161084E02
  1. Disconnect the connector A from the multiplex tilt and telescopic ECU.
    Text in Illustration 
    *a
    Front view of wire harness connector:
    (to Multiplex Tilt and Telescopic ECU)

  1. Connect the positive (+) battery terminal to terminal 10 (TIM+) and the negative battery terminal to terminal 1 (TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts up.

    OK:
    Steering wheel tilts up.

  1. Connect the negative (-) battery terminal to terminal 10 (TIM+) and the positive battery terminal to terminal 1(TIM-) of the tilt motor connector. Then confirm that the steering wheel tilts down.

    OK:
    Steering wheel tilts down.



4. INSPECT TELESCOPIC MOTOR


    C161085E02
  1. Disconnect the connector B from the multiplex tilt and telescopic ECU.
    Text in Illustration 
    *a
    Front view of wire harness connector:
    (to Multiplex Tilt and Telescopic ECU)

  1. Connect the positive battery terminal to terminal 2 (TEM+) and the negative battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column contracts.

    OK:
    Steering column contracts.

  1. Connect the negative battery terminal to terminal 2 (TEM+) and the positive battery terminal to terminal 6 (TEM-) of the telescopic motor connector. Then confirm that the steering column extends.

    OK:
    Steering column extends.



5. INSTALL LOWER STEERING COLUMN COVER


    C160536
  1. Attach the 2 claws to install the steering column lower cover.



6. INSTALL UPPER STEERING COLUMN COVER


    C162097
  1. Attach the claw to install the upper steering column cover.

  1. Attach the 4 clips to install the upper steering cover onto the instrument panel cluster finish panel.



    C160535
  1. Install the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    HINT:
    Turn the steering wheel to the right and left as necessary to install the 2 screws.