VACUUM SWITCHING VALVE (for ACIS) > ON-VEHICLE INSPECTION |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
| 2. INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) |
Disconnect the vacuum switching valve connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 37 to 44 Ω |
| 1 - Body ground | Always | 1 MΩ or higher |
| 2 - Body ground |
Check the vacuum switching valve operation.
![]() |
When applying a vacuum to port E, check that air is sucked into the filter.
If the result is not as specified, replace the vacuum switching valve assembly.
![]() |
Apply voltage across the terminals.
When applying a vacuum to port F, check that air is sucked into port E.
If the result is not as specified, replace the vacuum switching valve assembly.
Connect the vacuum switching valve connector.
| 3. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Attach the 2 V-bank cover hooks to the No. 1 V-bank cover bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover sub-assembly to attach the pins.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |