Home › ENGINE ยท 3UR-FBE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A165576E04
  1. Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
    Text in Illustration 
    *1
    V-bank Cover Grommet
    *2
    Pin
    *3
    No. 1 V-bank Cover Bracket
    *4
    V-bank Cover Hook



2. REMOVE CAMSHAFT POSITION SENSOR


A158617
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.