Home › ENGINE ยท 1UR-FE › ENGINE CONTROL SYSTEM › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).



1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

HINT:
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).



    A215439
  1. Install the air fuel ratio sensor to the front No. 2 exhaust pipe assembly by hand.



    A215440E02
  1. Using SST, tighten the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *a
    Fulcrum length

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.



2. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Connect the front No. 2 exhaust pipe assembly to the exhaust pipe support.

  1. Install a new gasket and the front No. 2 exhaust pipe assembly to the exhaust manifold LH with 3 new nuts.

    Torque:
    54 N*m{ 554 kgf*cm , 40 ft.*lbf }



3. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

HINT:
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).



    A215442
  1. Install the air fuel ratio sensor to the front exhaust pipe assembly by hand.



    A215443E02
  1. Using SST, tighten the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.



4. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(Click here)


5. INSPECT FOR EXHAUST GAS LEAK

HINT:
If an exhaust gas leak has been repaired, perform an inspection following the repair (Click here).

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.