AIR FUEL RATIO SENSOR > REMOVAL |
| 1. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Remove the 2 bolts and heat insulator from the heat insulator bracket.
| 2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) |
![]() |
for Front Differential Side:
Place matchmarks on the differential and propeller shaft flange.
| *a | for Front Differential Side |
| *b | Matchmark |
Remove the 4 nuts, 4 washers and disconnect the propeller shaft from the differential.
![]() |
for Transfer Side:
Place matchmarks on the transfer and propeller shaft flanges.
| *a | for Transfer Side |
| *b | Matchmark |
Remove the 4 nuts and 4 washers.
Remove the propeller shaft from the transfer flange.
| 3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Disconnect the heated oxygen sensor connector.
Remove the 2 bolts from the center exhaust pipe assembly.
Remove the 3 nuts.
Disconnect the front No. 2 exhaust pipe assembly from the exhaust pipe support to remove it.
Remove the 2 gaskets.
| 4. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Disconnect the air fuel ratio sensor connector.
Detach the 2 clamps and disconnect the heated oxygen sensor connector.
Remove the 2 bolts from the center exhaust pipe assembly.
Remove the 3 nuts, 2 gaskets and exhaust pipe assembly.
| 5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Using SST, remove the air fuel ratio sensor.
| 6. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Using SST, remove the air fuel ratio sensor.