HEATED OXYGEN SENSOR > INSTALLATION |
| 1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() |
Install the heated oxygen sensor to the front exhaust pipe assembly by hand.
![]() |
Using SST, tighten the heated oxygen sensor.
| *a | Fulcrum length |
| 2. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() |
Install the heated oxygen sensor to the front No. 2 exhaust pipe assembly by hand.
![]() |
Using SST, tighten the heated oxygen sensor.
| *a | Fulcrum length |
| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install a new gasket and the front exhaust pipe assembly to the exhaust manifold RH with 3 new nuts.
Install a new gasket and the front exhaust pipe assembly to the center exhaust pipe assembly with the 2 bolts.
Connect the air fuel ratio sensor connector.
Attach the 2 clamps and connect the heated oxygen sensor connector.
| 4. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Connect the front No. 2 exhaust pipe assembly to the exhaust pipe support.
Install a new gasket and the front No. 2 exhaust pipe assembly to the exhaust manifold LH with 3 new nuts.
Install a new gasket and the front No. 2 exhaust pipe assembly to the center exhaust pipe with the 2 bolts.
Connect the air fuel ratio sensor connector.
Connect the heated oxygen sensor connector.
| 5. INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) |
Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange, differential flange and transfer flange.
for Front Differential Side:
![]() |
Align the matchmarks on the differential and propeller shaft flange.
| *a | for Front Differential Side |
| *b | Matchmark |
Install the propeller shaft with the 4 washers and 4 nuts.
![]() |
for Transfer Side:
Align the matchmarks on the transfer and propeller shaft flange.
| *a | for Transfer Side |
| *b | Matchmark |
Connect the propeller shaft with the 4 washers and 4 nuts.
| 6. INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD) |
![]() |
Install the heat insulator to the heat insulator bracket with the 2 bolts.
| 7. INSPECT FOR EXHAUST GAS LEAK |