Home › ENGINE ยท 3UR-FBE › ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. The procedures should be performed by at least 2 people.
  2. Wear protective gloves when removing the exhaust pipe assembly.
  3. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  4. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. REMOVE PROPELLER SHAFT HEAT INSULATOR


C158452
  1. Remove the 2 bolts and heat insulator from the heat insulator bracket.



2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


C158457E02
  1. for Front Differential Side:

    1. Place matchmarks on the differential and propeller shaft flange.
      Text in Illustration 
      *a
      for Front Differential Side
      *b
      Matchmark

    2. Remove the 4 nuts, 4 washers and disconnect the propeller shaft from the differential.

      NOTICE:
      Use a rope to suspend the front edge of the propeller shaft.



    C158456E03
  1. for Transfer Side:

    1. Place matchmarks on the transfer and propeller shaft flanges.
      Text in Illustration 
      *a
      for Transfer Side
      *b
      Matchmark

    2. Remove the 4 nuts and 4 washers.

  1. Remove the propeller shaft from the transfer flange.



3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 bolts from the center exhaust pipe assembly.

  1. Remove the 3 nuts.

  1. Disconnect the front No. 2 exhaust pipe assembly from the exhaust pipe support to remove it.

  1. Remove the 2 gaskets.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Detach the 2 clamps and disconnect the heated oxygen sensor connector.

  1. Remove the 2 bolts from the center exhaust pipe assembly.

  1. Remove the 3 nuts, 2 gaskets and front exhaust pipe assembly.



5. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A158664E01
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



6. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A158664E01
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010