Home › ENGINE ยท 1UR-FE › ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. The procedures should be performed by at least 2 people.
  2. Wear protective gloves when removing the exhaust pipe assembly.
  3. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  4. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. REMOVE PROPELLER SHAFT HEAT INSULATOR


C158452
  1. Remove the 2 bolts and heat insulator from the heat insulator bracket.



2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the heated oxygen sensor connector.



    A215444E01
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A215447E01
  1. Detach the 2 clamps and disconnect the heated oxygen sensor connector.

  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010