EFI RELAY > ON-VEHICLE INSPECTION |
| 1. REMOVE INTEGRATION RELAY (UNIT E) |
Remove the engine room relay block cover.
![]() |
Using a screwdriver, detach the 2 claws and remove the integration relay from the engine room relay block.
Disconnect the 3 connectors.
| 2. INSPECT INTEGRATION RELAY (EFI RELAY) |

Measure the resistance of the EFI No. 1 fuse.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| EFI NO. 1 fuse | Always | Below 1 Ω |
![]() |
Measure the resistance of the EFI relay circuit.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1B-4 1C-1 - 1B-5 | When battery voltage is not applied to terminals 1B-2 and 1B-3 | 10 kΩ or higher |
| When battery voltage is applied to terminals 1B-2 and 1B-3 | Below 1 Ω |
| 3. INSTALL INTEGRATION RELAY (UNIT E) |
Connect the 3 connectors.
Install the integration relay to the engine room relay block.
Install the engine room relay block cover.