Home › ENGINE ยท 3UR-FBE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CONNECTOR HOLDER BLOCK


    A155992
  1. Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.



2. REMOVE ECM


    A182753E01
  1. Raise the 2 levers while pushing the locks on the 2 levers.

    NOTICE:
    Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

  1. Disconnect the 2 connectors.



    A155993
  1. Remove the 4 bolts and ECM.



3. REMOVE GASKET


    A198571
  1. Peel off the rubber part of the gasket.



    A198572E01
  1. Spray gasket remover or equivalent on the remaining tape of the gasket.

    NOTICE:
    When using gasket remover or equivalent, cover the ECM connector with a cloth.



    A198573
  1. Remove the tape of the gasket without using bladed objects.