Home › BODY ELECTRICAL › AUDIO / VISUAL › REAR DOOR SPEAKER (for CrewMax)

REAR DOOR SPEAKER (for CrewMax) > INSPECTION

for Preparation Click here



1. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for Standard)


E144966E48
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    2 Ω

    If the result is not as specified, replace the rear No. 1 speaker assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Rear No. 1 Speaker Assembly)



2. INSPECT REAR NO. 1 SPEAKER ASSEMBLY (for 12 Speakers)


E144966E48
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    1.8 to 2.6 Ω

    If the result is not as specified, replace the rear No. 1 speaker assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Rear No. 1 Speaker Assembly)



3. INSPECT REAR NO. 2 SPEAKER ASSEMBLY
  1. When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears.

    OK:
    Malfunction disappears.

    HINT:
    1. Connect the connectors to the rear No. 2 speaker assemblies.
    2. When there is a possibility that either the right or left rear No. 2 speaker assembly is defective, inspect by interchanging the right one with the left one.
    3. Perform the inspection above on both the LH and RH sides.