Home › BODY › SLIDING ROOF › SLIDING ROOF SWITCH ASSEMBLY (for CrewMax)

SLIDING ROOF SWITCH ASSEMBLY (for CrewMax) > INSPECTION

for Preparation Click here



1. INSPECT SLIDE ROOF MOTOR SWITCH


B167041E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (UP) - 5 (E)
    Tilt switch is pressed to up
    Below 1 Ω
    1 (UP) - 5 (E)
    Tilt switch is not pressed to up
    10 kΩ or higher
    2 (DOWN) - 5 (E)
    Tilt switch is pressed to down
    Below 1 Ω
    2 (DOWN) - 5 (E)
    Tilt switch is not pressed to down
    10 kΩ or higher
    4 (OPN) - 5 (E)
    Slide switch is pressed to open
    Below 1 Ω
    4 (OPN) - 5 (E)
    Slide switch is not pressed to open
    10 kΩ or higher
    3 (CLS) - 5 (E)
    Slide switch is pressed to close
    Below 1 Ω
    3 (CLS) - 5 (E)
    Slide switch is not pressed to close
    10 kΩ or higher

    If the result is not as specified, replace the slide roof motor switch.
    Text in Illustration 
    *1
    Tilt Switch
    *2
    Slide Switch
    *a
    Up
    *b
    Down
    *c
    Open
    *d
    Close
    *e
    Component without harness connected
    (Slide Roof Motor Switch)