OIL COOLER > INSTALLATION |
| 1. INSTALL TRANSMISSION OIL COOLER ASSEMBLY |
Coat 2 new O-rings with ATF, and install them to the transmission oil cooler.
Align the transmission oil cooler with the transmission oil cooler spacer and assemble them with the 3 bolts.
Connect the 2 transmission oil cooler hoses to the transmission oil cooler spacer with the 2 clips.
![]() |
Temporarily install the transmission oil cooler with transmission oil cooler spacer with bolt A.
Install the bolt B and tighten it to the specified torque. Then tighten bolt A to the specified torque.
Connect the 2 transmission oil cooler hoses with the 2 clips.
| 2. CONNECT WATER BY-PASS PIPE ASSEMBLY |
![]() |
Connect the 2 water by-pass hoses with the 2 clips and install the water by-pass pipe with the 2 bolts.
| *a | Yellow Paint Mark |
| *b | White Paint Mark |
| *c | RH Side |
| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install a new gasket and the front exhaust pipe assembly to the exhaust manifold sub-assembly RH with 3 new nuts.
| 4. ADD ENGINE COOLANT |
Add engine coolant.
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Install the radiator cap.*1
Start the engine and stop it immediately.*2
Allow approximately 10 seconds to pass. Then remove the radiator cap and check the coolant level. If the coolant level has decreased, add coolant.*3
Repeat steps *1, *2 and *3 until the coolant level does not decrease.
Install the radiator cap.*4
Set the air conditioning as follows.*5
| Item | Condition |
| Fan speed | Any setting except off |
| Temperature | Toward WARM |
| Air conditioning switch | Off |
Start the engine, warm it up until the thermostat opens, and then continue to run the engine for several minutes to circulate the coolant.*6
Stop the engine, wait until the engine coolant cools down to ambient temperature. Then remove the radiator cap and check the coolant level.*7
If the coolant level has decreased, add coolant and warm up the engine until the thermostat opens.*8
If the coolant level has not decreased, check that the coolant level in the radiator reservoir is at the FULL line.
If the coolant level is below the FULL line, repeat steps *4 through *8.
If the coolant level is above the FULL line, drain coolant until the coolant level reaches the FULL line.
| 5. ADJUST AUTOMATIC TRANSMISSION FLUID |
| 6. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK |
| 7. INSPECT FOR ENGINE COOLANT LEAK |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 8. INSPECT FOR EXHAUST GAS LEAK |