Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › OIL COOLER

OIL COOLER > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.


    A237558E01


    Text in Illustration 
    *1
    Radiator Reservoir
    *2
    Radiator Cap
    *3
    Radiator Drain Cook Plug
    *4
    Cylinder Block Drain Cock Plug

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.



2. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 3 nuts and front exhaust pipe assembly.

  1. Remove the gasket.



3. DISCONNECT WATER BY-PASS PIPE ASSEMBLY


    C292566
  1. Remove the 2 bolts and disconnect the 2 water by-pass hoses from the transmission oil cooler and the water by-pass pipe assembly.

    HINT:
    Use a container to catch any coolant which flows out of the water by-pass hoses.



4. REMOVE TRANSMISSION OIL COOLER ASSEMBLY


    C292569
  1. Disconnect the 2 transmission oil cooler hoses.

  1. Remove the 3 bolts and transmission oil cooler with transmission oil cooler spacer.



    C292568
  1. Remove the 3 bolts and disconnect the transmission oil cooler from the transmission oil cooler spacer.

  1. Remove the 2 O-rings.