Home › ENGINE ยท 3UR-FBE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
  1. Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
  2. After discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.

  1. Disconnect the cable from the negative (-) battery terminal.



    A194647
  1. Disconnect the 2 fuel pump ECU connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine. After the engine has stopped on its own, turn the ignition switch off.

    HINT:
    DTC P0171/0174 (system too lean) may be set.

  1. Crank the engine again, and then check that the engine does not start.

  1. Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.

  1. Connect the 2 fuel pump ECU connectors.



2. REMOVE V-BANK COVER SUB-ASSEMBLY


    A165576E04
  1. Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
    Text in Illustration 
    *1
    V-bank Cover Grommet
    *2
    Pin
    *3
    No. 1 V-bank Cover Bracket
    *4
    V-bank Cover Hook



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A187008
  1. Disconnect the vacuum hose from the air cleaner hose assembly.

  1. Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose assembly.



4. DISCONNECT VENTILATION HOSE


    A198623
  1. Disconnect the ventilation hose.



5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


6. REMOVE NO. 3 ENGINE COVER


7. REMOVE FUEL PRESSURE PULSATION DAMPER CAP


    A194638
  1. Remove the 2 fuel pressure pulsation damper caps.



8. REMOVE FUEL PRESSURE PULSATION DAMPER COVER


    A194639
  1. Remove the 4 bolts and 2 fuel pressure pulsation damper covers.



9. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    A194640
  1. Pull the 2 fuel pressure pulsation dampers out of the fuel delivery pipes to remove it.