DTC P062F Internal Control Module EEPROM Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| P062F | ECM internal error (EEPROM) | ECM |
| Related DTCs | P062F: Internal control module EEPROM error |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Once per driving cycle |
| Duration | 3 times |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present | None |
| Time after engine start | 10 seconds or more |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Permanent fault code data | Mismatch (3 times or more) |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P062F) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| No output | A |
| P062F | B |
|
| ||||
| A | ||
| ||