DTC P062F Internal Control Module EEPROM Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| P062F | There is an ECM internal error (EEPROM) (1 trip detection logic). | ECM |
| Related DTCs | P062F: Internal control module EEPROM error |
| Required sensors/Components (Main) | ECM |
| Required sensors/Components (Related) | - |
| Frequency of operation | Once per driving cycle |
| Duration | 3 times |
| MIL operation | Immediate |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not stored | None |
| Engine speed | Less than 10000 rpm |
| Time after engine start | 10 seconds or more |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Permanent fault code data | Mismatch (3 times or more) |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P062F) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the ignition switch off and turn the Techstream off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Wait 30 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| No DTC is output | A |
| P062F is output | B |
|
| ||||
| A | ||
| ||