Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › DRIVER SIDE KNEE AIRBAG ASSEMBLY

DRIVER SIDE KNEE AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)


B165843
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.



4. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax)


B165841
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.



5. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the nut.

  1. Detach the 2 clips and remove the cowl side trim board LH.



6. REMOVE INSTRUMENT SIDE PANEL LH


    B355333
  1. Using a moulding remover B, detach the 3 claws, 4 guides and remove the instrument side panel LH.



7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Operate the tilt lever to fully extend and raise the steering column.



    B355337E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 bolts <A>.

  1. Detach the 9 clips, 2 claws and remove the lower instrument panel finish panel sub-assembly LH.

  1. Disconnect each connector.



    B355336
  1. Detach the 3 hooks and disconnect the hood lock control lever from the lower instrument panel finish panel sub-assembly LH.



  1. Pull and slide the hood lock control cable, rotate the hood lock control cable, and then disconnect the hood lock control cable from the hood lock control lever.


    B355339



8. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.