Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


E189909E02
  1. Check the voltage.

    1. Connect the battery positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 5 (E).

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      1 (B) - 2 (T)
      0
      10.4 to 11.2 V
      1
      8.52 to 9.24 V
      2
      6.6 to 7.32 V
      3
      4.68 to 5.40 V
      4
      2.76 to 3.48 V
      5
      0.84 to 1.56 V

      If the result is not as specified, replace the headlight leveling switch.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)



    E189909E03
  1. Check the illumination.

    1. Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (ILL+)
      Battery negative (-) → Terminal 4 (ILL-)
      Illuminates

      If the result is not as specified, replace the headlight leveling switch.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)