EGR VALVE > INSTALLATION |
| 1. INSTALL EGR VALVE BRACKET |
![]() |
Install the EGR valve bracket with the 3 bolts.
| 2. INSTALL NO. 3 EGR PIPE SUB-ASSEMBLY |
![]() |
Install a new gasket and the No. 3 EGR pipe with the 2 nuts.
| 3. INSTALL EGR INLET |
![]() |
Install a new gasket and the EGR inlet with the 2 bolts.
| 4. INSTALL EGR VALVE ASSEMBLY |
![]() |
Install a new gasket to the intake manifold.
![]() |
Install a new gasket to the No. 2 EGR pipe.
![]() |
Temporarily install the EGR valve assembly to the intake manifold with the 2 bolts and 4 nuts.
![]() |
Using several steps, uniformly tighten the 2 bolts and 4 nuts in the sequence shown in the illustration.
| 5. CONNECT NO. 13 WATER BY-PASS HOSE |
![]() |
Connect the No. 13 water by-pass hose.
| 6. CONNECT NO. 12 WATER BY-PASS HOSE |
![]() |
Connect the No. 12 water by-pass hose.
| 7. INSTALL AIR CLEANER HOSE ASSEMBLY |
![]() |
Install the air cleaner hose with the 2 clamps.
Connect the ventilation hose and vacuum sensing hose.
| 8. ADD ENGINE COOLANT |
Add engine coolant.
![]() |
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Press the inlet and outlet radiator hoses several times by hand, and then check the coolant level. If the coolant level is low, add coolant.
Install the radiator cap.
Start the engine and warm it up until the thermostat opens.
Maintain the engine speed at 2000 to 2500 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine, and wait until the engine coolant cools down to ambient temperature.
![]() |
Check that the coolant level is between the FULL and LOW lines.
If the coolant level is below the LOW line, repeat all of the procedures above.
If the coolant level is above the FULL line, drain coolant so that the coolant level is between the FULL and LOW lines.
| 9. INSPECT FOR ENGINE COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 10. INSTALL V-BANK COVER SUB-ASSEMBLY |
![]() |
Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.