Home › ENGINE ยท 1UR-FE › EMISSION CONTROL › EGR VALVE

EGR VALVE > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A214569
  1. Disconnect the vacuum sensing hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



    A215892E01

  1. Tighten the radiator drain cock plug by hand.



4. DISCONNECT NO. 12 WATER BY-PASS HOSE


    A214277
  1. Disconnect the No. 12 water by-pass hose.



5. DISCONNECT NO. 13 WATER BY-PASS HOSE


    A217531
  1. Disconnect the No. 13 water by-pass hose.



6. REMOVE EGR VALVE ASSEMBLY


    A214280
  1. Disconnect the 3 clamps and connector.



    A214279
  1. Remove the 4 nuts.



    A214281
  1. Remove the 2 bolts and EGR valve.



    A214876
  1. Remove the gasket from the No. 2 EGR pipe.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



    A214282
  1. Remove the gasket from the intake manifold.



7. REMOVE EGR INLET


    A214284
  1. Remove the 2 bolts, EGR inlet and gasket.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



8. REMOVE NO. 3 EGR PIPE SUB-ASSEMBLY


    A214285
  1. Remove the 2 nuts, No. 3 EGR pipe and gasket.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



9. REMOVE EGR VALVE BRACKET


    A214283
  1. Remove the 3 bolts and EGR valve bracket.