Home › BODY › WINDSHIELD / WINDOWGLASS › BACK WINDOW GLASS (for Regular Cab and Double Cab)

BACK WINDOW GLASS (for Regular Cab and Double Cab) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Power Slide Type)


B227090E01
  1. Check the operation of the power window regulator motor.

    1. Apply battery voltage to the power window regulator motor.

    2. Check that the motor gear rotates smoothly as follows.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 2
      Battery negative (-) → 1
      Motor gear rotates clockwise
      Battery positive (+) → 1
      Battery negative (-) → 2
      Motor gear rotates counterclockwise

      If the result is not as specified, replace the regulator motor.



2. INSPECT NO. 1 BACK POWER WINDOW RELAY (except 3UR-FBE)
  1. Remove the power window relay from the engine room relay block.



    B106753E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied between terminals 1 and 2
    Below 1 Ω
    When battery voltage is applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    When battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



3. INSPECT NO. 2 BACK POWER WINDOW RELAY
  1. Remove the power window relay from the engine room relay block.



    B106753E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied between terminals 1 and 2
    Below 1 Ω
    When battery voltage is applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    When battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



4. INSPECT NO. 3 BACK POWER WINDOW RELAY (for 3UR-FBE)
  1. Remove the power window relay from the engine room relay block.



    B106753E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied between terminals 1 and 2
    Below 1 Ω
    When battery voltage is applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    When battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.