Home › ENGINE ยท 1GR-FE › EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


2. REMOVE AIR CLEANER CAP AND HOSE


    A239075
  1. Remove the air cleaner cap and hose.

    1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

    2. Loosen the clamp.

    3. Detach the 4 hook clamps, and then remove the air cleaner cap and hose.



3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
  1. Remove the air cleaner filter element.



    A239077
  1. Remove the 2 bolts and air cleaner case.



4. REMOVE FRONT FENDER APRON SEAL REAR LH
  1. Remove the 5 clips and fender apron seal.



5. REMOVE FRONT FENDER APRON SEAL REAR RH
  1. Remove the 5 clips and fender apron seal.



6. REMOVE MANIFOLD STAY


    A237695
  1. Remove the 3 bolts and manifold stay.



7. REMOVE AIR TUBE


    A239078
  1. Remove the 2 bolts, 2 nuts and air tube.

  1. Remove the 2 gaskets from the air tube.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A237696
  1. Remove the 3 bolts and heat insulator.



9. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    A237697
  1. Remove the 6 nuts, manifold and gasket.



10. REMOVE NO. 2 MANIFOLD STAY
  1. Disconnect the wire harness connector.



    A237698
  1. Remove the 3 bolts and No. 2 manifold stay.



11. REMOVE NO. 2 AIR TUBE


    A239085
  1. Remove the 2 bolts, 2 nuts and No. 2 air tube.

  1. Remove the 2 gaskets from the No. 2 air tube.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



12. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A237699
  1. Remove the 3 bolts and heat insulator.



13. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    A237700
  1. Remove the 6 nuts, manifold and gasket.