Home › ENGINE · 3UR-FBE › EMISSION CONTROL › AIR PUMP

AIR PUMP > INSPECTION

for Preparation Click here



1. INSPECT AIR PUMP ASSEMBLY


  1. Check the heater resistance.



      A256388E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (APH+) - 3 (APHG)
      -20°C (-4°F)
      4.4 to 20.0 Ω
      -10°C (14°F)
      3.9 to 18.0 Ω
      0°C (32°F)
      3.5 to 16.0 Ω
      10°C (50°F)
      3.2 to 15.0 Ω
      20°C (68°F)
      3.0 to 14.0 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Air pump)
      If the result is not as specified, replace the air pump assembly.